HOME

GAUGE 1 FINESCALE
READY MADE FINESCALE PLASTIC POINTS

There is a dedicated group of enthusiasts who prefer to make and run their stock set to the finescale standards, to this end we now produce a limited range of ready made turnouts. with the introduction of the code 180 fine scale rail and fine sleeper units, it has been possible to produce the turnouts with the check chairs set at 1.75mm instead of the usual 3mm gap. The Points will include the second tiebar as standard, and the Slide chairs have the 'nut' detail added.

Stainless steel is the most popular and so this is stocked, with nickel silver made to order.

Please use the Shopping Cart to get your Discount

Click the drop down menu to select the item and the click 'Add To My Order'. Adjust the number required & click 'Apply'. Then 'Continue Shopping'. The weight of each item is added to the order, you then choose the applicable postage. Also you can choose a 5% discount if you are paying by Cash or 3% if paying by Cheque, Bank Transfer or PayPal Gift. When finished ordering items, click 'Checkout'.

G1MRA and Gauge 3 Society members enjoy instant 14 day credit up to £400, so you can order now and pay later, just enter your membership number in the Checkout section. Overseas orders - make a provisional order and do not pay, I will send you the postage cost.

Please note - that the term 'Finescale' refers to the check chair gap set to 1.75mm and therefore 'Standard' wheel sets will not normally run through without riding up on the check rails, other than that 'Standard' gauge will run on the track.

Modellers Information - to plan your layout, these are the sizes for the various turnouts measured from centre of fishplate to centre of fishplate. The size can be reduced by 1" (25mm) if 1 of the 2 standard sleepers is removed after the blade rail end, and a further 1" (25mm) if no standard sleepers are used at the nose end.

5000mm Finescale left or right hand = 31.5" (800mm) or 5000mm 'Y' = 23.5" (597mm)

Finescale 5000mm Radius Pointt
Turnout Track Power (Extra and Made to Order)
RAIL BUILT BUFFER STOP

Gauge 1 Ready Made Rail Built Buffer Stop with code 180 bullhead stainless steel rail and 'Fine' sleepers, hardwood buffer beam, 2 x 15mm ASA Fishplates and 4 x 10mm 19 gauge escutcheon fixing pins. These are assembled using the best M1.6mm A2 stainless steel bolts for longevity.

Ready Made Buffer Stop
OTHER ITEMS TO GO WITH THE TRACK ARE FOUND IN THE 'G1 FINE & STANDARD TRACK'